Henkel BONDERITE® S-ST 6776-LO Paint Remover (formerly Turco® 6776-LO) is a low-odor, thixotropic paint remover developed for effective stripping of such resistant surfaces such as epoxies, epoxy primers, polyurethanes and similar catalyzed paints. . Henkel BONDERITE® S-ST 6776-LO Paint Remover (formerly Turco® 6776-LO) offers a significant advance in workplace safety. Does not contain methylene chloride, chlorinated solvents, phenols, chromates, ammonia or amines. Fully compatible with aircraft / aviation NESHAP. Henkel BONDERITE® S-ST 6776-LO Paint Remover (formerly Turco 6776-LO) can be used on aluminum, mild steel, cast iron and titanium when used as specified. Henkel BONDERITE® S-ST 6776-LO Paint Remover (formerly Turco 6776-LO) is not recommended for use on high strength steel or magnesium.
Instructions for Use
Application: Apply a homogeneous coating to the stripped surface with non-atomizing spray. Give enough time for the stripper to work. The higher the temperature, the higher the performance. Rinsing with a stiff bristle brush will help remove polish. Repeat as needed.
Removal: Sweep out loosened paint and stack of TURCO 6776-LO, then rinse with high pressure water.
Disposal Information: Dispose of used remover and paint residues according to local, state and state regulations.
Concentrates:
(1) If possible, transfer it to take-back center for recycling or reuse. (2) It is transported to the licensed hazardous waste processing or disposal site for disposal as hazardous waste within the scope of relevant local, regional and regional regulations. (3) Small amounts can be dissolved in water and treated as described below. If local regulations allow, clarified water can be released into the sewer.
Spent solution and rinses: Discard according to (1) or (2) above, or heavy metals (if present) can be precipitated by adjusting the pH to 9.5 - 10.5; The pH of the separated water should then be readjusted to pH 7.0 - 8.0. If local regulations allow, clarified water can be released into the sewer.
ATTENTION! TURCO 6776-LO contains formic acid. Avoid contact with eyes, skin, and clothing. Do not take it internally. Do not spray in confined areas. Avoid breathing vapor for long periods. Use with adequate (outdoor equivalent) ventilation.
Protective clothing such as chemical face shield or goggles and gloves should be worn, and a NIOSH approved respirator equipped with a mechanical filter for fog conditions.
Store containers at a temperature between 2 ° C and 40 ° C.
Features
Light scent
Reduced air pollution, 0 lb / gal HAPS; <2 mm Hg VOC Vapor Pressure
Significantly lower waste disposal costs
Easily managed on site (see MSDS)
Less used scrapers than conventional methylene chloride scrapers
No flash points to boil (Pensky-Martens)
Used as delivered, No mixing or dilution required
Excellent adhesion to vertical and overhead surfaces
Positive compressed air masks are not required
| Paketleme | 20 KG or 23 KG |
Once the user has seen at least one product this snippet will be visible.